Support me on Patreon www.patreon.com/madeinpolandd Hi. My name is Darek and in this video I'll show you how I made a Spot Welder DIY using simple tools. The main assumption was to make this without special tools. As you seen, mostly I used a drill and an angle grind and the end result came out really cool. Here are some cheap tools that I use and recommend: https://goo.gl/n3wHdv - LASER ENGRAVER https://goo.gl/Sh32kh - 90 Degrees Corner Clamp https://goo.gl/yBn5Ta - 90 Degrees Angle Aluminum Alloy Rectangular Clamp https://goo.gl/sgS5eg - 2.5 Inch Plat Nose Pliers Aluminum Alloy Vise https://goo.gl/GXtWTc - Vise Workbench Swivel 360° Rotating Clamp https://goo.gl/yk56NG - 5Pcs 15-35mm Professional Woodworking Drill Bits Set https://goo.gl/R8q7z2 - 4-20mm HSS Step Drill Bit https://goo.gl/9jmNei - 10pcs 16mm-50mm Steel Carbide Hole Saw https://goo.gl/quNNcU - Tap and Die Set Costs: A transformer from the scrapyard - $ 2.00 A welding cable 1 meter - $ 2.00 Connectors - $ 1.00 An aluminum square tubing - $ 4.00 Door hinges - $ 2.00 The rest of the materials I had in the workshop, but if I had to buy them, would not cost more than $ 10.00 --------------------------------------------------------------------------------------------------- $ 21.00 (my cost $ 11.00) The welder works really, really well. After a few minutes of work, only the aluminum arms are warm. Thanks to the fact that they are made of aluminum, they quickly give off the heat and the entire transformer and the coils are cold. Some materials used to build this: https://goo.gl/fFvBUR - Welding cabel https://goo.gl/CjG71M - Connectors https://goo.gl/5kNk8b Aluminum Tube Square Gearbest.com site I work with has great sales now, you can save up to 80% !!! check out the links below: https://goo.gl/tN4QBC https://goo.gl/22xgbX https://goo.gl/5Efo8u ----------------------------------------­­------------------------------------ Follow me on: INSTAGRAM www.instagram.com/made_inpoland/ FACEBOOK www.facebook.com/1187887134621389/